×
How To Measure and Cut-To-Size Policy | Close it
Cut-To-Size Items are Non-Returnable!
Cut-To-Size Items are Non-Returnable!
As per our Shipping and Returns Policy, custom cuts and fabricated parts are non-returnable. If you need an over- or undersized item, note it under \"Comments\" during Checkout. Cut-to-size orders have an acceptable cut tolerance of 1/8" (0.125"), so clarify if the adjustment is to be made on the (+) or (-) side of the saw blade. Please review our full return and shipping policy here.
Measure Twice, Cut OnceSince custom cuts and fabricated parts are non-refundable, be very careful while measuring your dimensions. As each cut is nominal, even the slightest miscalculation could be costly.
How to Use a Measuring TapeExtend your tape measure several inches to find the 1 and 2 inch markers. In between the inch markers you’ll find 16 equally spaced tick marks.
Measure by counting the increments beyond the nearest inch. As the increments decrease, so does the length of the mark. For example, 1/2\" has a bigger mark than 1/4\" which has a bigger mark than 1/8\". The smallest mark follows at 1/16\". Please be aware that some measuring tapes may have even smaller increments.
Features of a Measuring Tape: Sliding End HookThe sliding end hook is designed for two different types of measurements. An outside measurement (where the hook of the tape hangs over an edge), requires the hook to slide out a bit to account for the thickness of the material. When making an inside measurement (where the hook will push up against a surface), the clip slides in, again, accounting for its thickness. The measuring tape self-adjusts to guarantee an accurate measurement (as far as the tape is concerned).
INSERTS- ROLL END BEARING- UHMW- 3/8" THRU BORE
Roll End Bearing Inserts
SKU:
ESTIMATED SHIPPING TO 06828: $31.46
Description
Roll end bearing inserts are fully machined from UHMW stock and designed to work with metal and plastic bearings and housings. These inserts are manufactured in one piece so you have a solid UHMW bearing to withstand heavier loads. They are highly chemically resistant and made from FDA, USDA, NSF and 3A Dairy compliant material. In corrosion sensitive applications, UHMW is the preferred material and is routinely used in food contact applications where wash-down and lubricity are concerns. All of our parts match their metal counterparts for height, centerline, and bolt patterns and are, therefore, interchangeable dimensionally. 3/8" Thru Bore.
Nylon and UHMW plastics reduce energy loss and are used for long life wear parts.
Frequently Asked Questions
What sets Interstate Advanced Materials apart?
Interstate Advanced Materials empowers customers to choose their pricing by maintaining a membership, available through tier levels that unlock access to exclusive pricing as well as shipping and volume discounts
What is Interstate Advanced Materials's Shipping Policy?
Shipping will vary based on whether your order contains custom or cut-to-size products. Details about shipping can be found here.
Is your site secure?
Yes, we implement a variety of security measures to maintain the safety of your personal information. Your information is protected both online and offline.
Disclaimer: Interstate Advanced Materials makes no representations about any of its products that are modified in any way after they leave its possession, nor do its representations apply when any of its products are improperly used or stored. Each customer of Interstate Advanced Materials bears full responsibility for making its own determination as to the suitability of each material, product, recommendation or advice provided by Interstate Advanced Materials. Each customer of Interstate Advanced Materials must identify and perform all tests and analyses necessary to assure that its finished parts incorporating materials from Interstate Advanced Materials will be safe and suitable for use under end-use conditions.
